SPUG: Report on SPUG->E(0)
Andrew Sweger
andy at n2h2.com
Thu Jan 27 16:22:17 CST 2000
On Jan 27, 2000 @ 11:21am, Jamie Shaffer wrote:
> 'Twas I. Unfortunately, I didn't actually do the embedding, I just became
> responsible for re-compiling Perl 5 for it, including removing all the 'hard
> coded' library paths, adding the DynaLoader, getting it to use the same
> environment variables that the rest of our tool uses, and putting all changes
> to the original Perl source under version control with happy make files for
> 4 platforms. (NT, HPUX, Solaris, Linux)
Yeah. Sure. Everyone knows this stuff inside and out. Yikes! Are you sure
you wouldn't want to share all this in more detail at a SPUG? I'd show up
(of course, I always do). I'm sure there's at least a few others too.
> I suspect there is someone much more knowledgeable about the actual
> embedding process out there in SPUG-land. However, if nobody else
> volunteers, I can try to trim that part out of our code base into a smaller
> working example for some far-future ESPUG meeting.
Sure, but they're not paying attention to this list 'cause they're too
busy hacking. I say go for it.
--
Andrew Sweger <andy at n2h2.com> | N2H2, Incorporated
v=206.336.2947 f=206.336.1541 | 900 Fourth Avenue, Suite 3400
Advanced Technologies | Seattle WA 98164-1059
Development | http://www.n2h2.com/
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
POST TO: spug-list at pm.org PROBLEMS: owner-spug-list at pm.org
Seattle Perl Users Group (SPUG) Home Page: http://www.halcyon.com/spug/
SUBSCRIBE/UNSUBSCRIBE: Replace ACTION below by subscribe or unsubscribe
Email to majordomo at pm.org: ACTION spug-list your_address
More information about the spug-list
mailing list